SEBS

TPE-S (SEBS)

NEXGEN S Flex

Nexgen S Flex is a Thermoplastic elastomer based on Styrenic Block Copolymers (TPE-S), which are physical alloys between polyolefines (PS/PP/PE) “ hard segment “ and styrene block polymers (SBS,SEPS, SEBS, SEEPS) “soft segment”, in addition to different fillers, plasticizers, and stabilizers. Hardness: 0A-60D          Density:0.89-1.25
Why you should use our TPE-S
  • Resistance to weathering, ozone, UV, and impact
  • 100% Recyclable
  • Translucent and transparent variants
  • High cost savings on processing
  • Non-hygroscopic, predrying is not necessary
  • Density changes between 0,89 and 1,25 g/cm³
  • Low cost solutions are possible
  • Service temperature -40˚C to +130˚C
  • Wide hardness range (0 ShA up to 66 ShD)
  • Easy to color
  • Resistance to acids, bases, and detergents
  • Adheres to PA, ABS, PS and PC, engineering plastics
  • Adheres to PVC
  • Very good abrasion resistance
  • Some grades are resistant to bacteria and fungus growth
  • Antistatic compounds are possible
  • Almost all grades conform to FDA regulations